Orbit57896 6-Station Outdoor Swing Panel Sprinkler System Timer, Green

Fast Shipping! Arrived same day on time and was able to install it. Simple to program. I have 2 of these now. They work great!

My Rainbird timer has been slowly dying and I needed to replace it. I was looking for a timer for an outdoor location without a lot of bells and whistles to control my 6 zone sprinkler system. Oh yeah...and I didn't want to pay a lot for it. The Orbit 57896 seemed to cover everything I needed to do and the price was very reasonable.My old timer was hardwired, but the Orbit comes with an attached cord and plug. What to do? I could have cut the plug off and hardwired it, but there was a problem with that idea. The conduit holes (one for power, one for the low voltage valve wires) in the old timer box were a different spacing than the Orbit, so I would have had to re-do the conduit. I also liked the idea of having an outdoor outlet box in the area where the timer was located, so that tipped the decision.I discovered that the circuit breaker supplying power to the timer was not a GFCI breaker. Since the location is outside, I had to either replace the circuit breaker or use a GFCI outlet. I decided that the safest approach was to replace the breaker. I cut the PVC conduit and replaced the old junction box with an exterior outlet box with a weather proof cover. The one thing I don't like about the design of the Orbit timer is that the line cord is not sealed where it exits the box. I sealed it with caulk to prevent water entering the box in a windy rain storm.I number of reviewers have dinged this timer because of programming issues. I found the instruction manual to be very understandable and the unit easy to program (YMMV). Setting the time is a little annoying, but I should only have to do that once a year when replacing the battery. Here's a tip: before I installed the timer outside, I programed it sitting comfortably at my kitchen table with a cup of coffee. Plug the unit in, pull the strip that activates the battery and you're ready to program. When you unplug the unit and install it outside, the battery allows it to remember the program. Once you hang it and connect the wires, just turn the dial to "Automatic" and you're good to go.You will have to decide how often you want to run your system. Conveniently, the Orbit 57896 allows 3 different options for this: by the day of the week, by a fixed interval or by odd or even days. Once the unit is programmed and set to "Automatic", the display alternately shows the current date and time and then the day and time of the "Next Start", so you will always know where you are in the cycle.Pro: Rugged design; easy to install; easy to program; big, east to read display; can be used either indoors or outdoors; great priceCon: Box not sealed around the power cord

Easy to install. Easy setup instructions.

I was replacing a really old controller that is difficult to program, and doesn't have features like rain delay. This unit worked great for about a day, then started showing a "No AC" in the display, and would not activate the sprinkler actuators. Customer support said that is reading as not plugged in or no power, but the outlet was fine and trying other outlets did not help. Pulling the battery and leaving it out for a while reset the unit. But only got one test cycle through the sprinklers and the "No AC" error was back.Customer support said it might be due to bad actuators and I tested the lines at the end that goes into the unit and all had enough resistance as they said to check for and all work with the old controller. Perhaps if all the old actuators (3 new and 3 old) were replaced it would work, but replacing working actuators in order to possibly make it work isn't very appealing. So I'm not sure if the unit was bad or I have one or more problems elsewhere. Sent back and put the old one back on the wall.4 stars since the programming on this is easy and things like the manual rain delay is nice. I was going to add an automatic rain sensor as well, but didn't get the chance.

My Orbit 57896 6-Station went out after 15 yrs. Thought I would try a Rain Bird SST600IN. Big mistake. After numerous times I could never get it to water even and odd days.(watch multiple youtube) In commiefornia you get punished for using too much water. Bought an orbit again and works great.

Very easy to program

Easy to install, one of the easiest to program & operate.

With 3 programable schedules, A as your primary leaves B and C to do as you wish like, water an area more frequently like flowers but with use less water each time.The display is big but not lit. This timer uses a replaceable (not rechargeable) CR2032 button battery, so you can program your timer before installing it. Depending on your local power failure rate, check and or replace the battery accordingly.I didn't do this but I would recommend to practice installing a wire before installing the timer so you can better see what you are doing. The spring loaded tabs to hold open the wire gripper so the wire can be inserted can be a bit frustrating. All the wires insert from the bottom of a terminal strip so it is impossible to see the wire being inserted. I have installed plenty of components with this type connection, this one was more difficult.When I installed my 6 zone sprinkler system I included a master valve this time, the other two I did not. I have had a seeping zone valve all summer, I will replace it now that it has cooled off. With out a master valve, a seeping valve would leak 24-7, wasting water until I replaced it.It's mentioned in the manual where to install the master valve hot wire, at the pump connection but easy to miss if in a hurry to get the timer installed.