HiFiBerry HighPi Raspberry Pi Case - Raspberry Pi4

A truly fantastic product. I'm using it for my RaspberryPI 4 with a Digi+ hat from HiFi Berry that I use with Roon.Took almost no time to insert the computer into the case - it just snaps in. Had to remove one cutout for the HiFiBerry outputs - that took 1 minute.Another minute to snap on the cover and 30 seconds to install the rubber feet.Grand total - about 4 minutes and it looks great (even though I'll probably hide it near my processor).

Theses cases actually fit, no mods required to make the ports line up, other cases aren’t even close fitting the USB ports

Works great with a Raspberry Pi 4 and the HifiBerry DAC + hat. I Just wish it were little heavier as connected cables tend to move the device around. That's nitpicking though (just put a weight on top of it if needed), overall I'm happy with it as it is easy to open if needed and once you cut out the "ports" for the audio out RCA jacks, everything fits well and looks pretty good.

Super easy case to use and it fits the POE Hat (C) (https://www.amazon.com/dp/B0928ZD7QQ?ref=ppx_yo2ov_dt_b_product_details&th=1) which is what I was looking for.

I really need a tall case for a project. This would have been perfect, except for some reason, the HDMI Micro 1 and 2 ports on the side are replaced with a normal HDMI port. The two micro ports won't fit in the cutout. So, it's a Pi4 case with a cutout for a Pi3 component, so neither will fit. Total waste of money.

It took a minute to figure out but it is really intuitive to put together. Just look closely at the way the parts are cut.

This fit the raspberry pi 4b snuggly, however I had to bore out the hole for the USB-C power adapter. Without doing so, the power adapter couldn't plug in far enough to keep from falling out.

muy buena carcasa